What are the parts of a lead acid battery?

The lead acid battery is most commonly used in the power stations and substations because it has higher cell voltage and lower cost. The various parts of the lead acid battery are shown below. The container and the plates are the main part of the lead acid battery.

How are lead acid battery plates made?

Two lead plates after being subjected to hundreds of reversals will acquire a skin of lead peroxide thick enough to process sufficiently high capacity. This process of making positive plates is known as formation. The negative lead acid battery plates are made by same process.

What is the construction of a lead acid battery cell?

The construction of a lead acid battery cell is as shown in Fig. 1. It consists of the following parts : Anode or positive terminal (or plate). Cathode or negative terminal (or plate). Electrolyte. Separators. Anode or positive terminal (or plate): The positive plates are also called as anode. The material used for it is lead peroxide (PbO 2).

What is a lead acid battery?

The equation should read downward for discharge and upward for recharge. The battery which uses sponge lead and lead peroxide for the conversion of the chemical energy into electrical power, such type of battery is called a lead acid battery. The container, plate, active material, separator, etc. are the main part of the lead acid battery.

What is a positive plate in lead acid battery?

This results in increase of superficial area by a large extend. The main feature of construction of lead acid battery is to accommodate a large volume of active materials i.e. PbO 2 in active plate. Positive plates are usually produced by Plante Process and the plates are known as Plante Plates.

How to increase the surface area of a lead acid battery plate?

It is seen that since active material on a Plante plate consists of a thin layer of PbO 2 formed on and from the surface of the lead plate, it must be desirable to have a large superficial area in order to get an appreciable volume of it. The superficial area of lead acid battery plate can be increased by grooving or laminating.